| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Low runout ER collets http://www-.luthiersforum.com/forum/viewtopic.php?f=10106&t=47058 |
Page 1 of 1 |
| Author: | RandK [ Thu Jan 14, 2016 8:41 pm ] |
| Post subject: | Low runout ER collets |
Anybody using low runout ER collets like these Techniks for fret slotting or inlay ? http://www.techniksusa.com/metal/DNAcol ... ollets.htm I've seen other expensive alternatives with a bizarre looking holder. The Techniks need a special nut and wrench but the cost isn't that bad. |
|
| Author: | Bobc [ Fri Jan 15, 2016 11:50 am ] |
| Post subject: | Re: Low runout ER collets |
I use them. Great collet for the money. No problems with fret slotting. Very accurate. |
|
| Author: | RandK [ Sun Jan 17, 2016 8:44 pm ] |
| Post subject: | Re: Low runout ER collets |
Thanks Bob, I'll place an order for some. |
|
| Author: | Andy Birko [ Mon Jan 18, 2016 12:12 am ] |
| Post subject: | Re: Low runout ER collets |
Those look pretty cool. Where are you buying them? |
|
| Author: | RandK [ Mon Jan 18, 2016 10:50 am ] |
| Post subject: | Re: Low runout ER collets |
Western Tool, westtool.com is my local distributor although these are likely a drop ship item. There must be a local distributor in your area, you might try calling Techniks to ask. The TIR spec is the same on these as their regular collets but a very different animal. If I'm going to buy a few new ones, I'd rather buy something with better specs. Not sure if they are improved enough to replace something that isn't worn out yet. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|